Quick question

7 posts / 0 new
Last post
Joined: 03/16/15
Posts: 53852
Quick question

I am working more on real paper pages lately, and I was wondering... when you put very thick 3-D elements on your layout, how do you get it in the sleeve? Or what do you do? :dontknow: Thanks in advance!

momma24/7's picture
Joined: 10/17/04
Posts: 752

I usually don't have a problem with them going into the sleeve. Sometimes I do have to wiggle/shimmy it down into the sleeve.

Joined: 03/16/15
Posts: 53852

if i have a paper that isnt fitting its usually because the page is too wide and i just slice a little off. i just took some shells off my beach page because it was too lumpy. it was going to ruin the other pages in the book so i took them off.

Joined: 03/16/15
Posts: 53852

Just a lot of wiggle jiggle. Make sure your 3D elements are well fastened so that they don't pop off as you slide the page into your scrapbook.

Joined: 03/16/15
Posts: 53852

Yep, just a little wigglin'. I also just make sure the protector sheet is not getting jammed under the 3D elements because it will pop off.

And I also trim a little off my sides if it is to wide.

Joined: 03/16/15
Posts: 53852

Thanks ladies! Biggrin

Joined: 07/19/05
Posts: 230

what they said Wink